Saving The Configuration Changes - Grandstream Networks HT818 Administration Manual

3. Open the web browser on your computer.
4. Enter the default LAN IP address (192.168.2.1) in the address bar of the browser.
5. Enter the administrator's password to access the Web Configuration Menu.
6. Make sure to reboot your device after changing your settings to apply the new configuration.
Please make sure that your computer has a valid IP address on the range 192.168.2.x so you can access the web GUI of your HT818.
Web UI Access Level Management
There are two default passwords for the login page:
User Level
End User Level
Administrator Level
Viewer Level
The password is case sensitive with maximum length of 25 characters. When changing any settings, always submit them by pressing
Update or Apply button on the bottom of the page. After submitting the changes in all the Web GUI pages, if a reboot is required, the
web page will prompt the user to reboot by offering a reboot button on the web page.

Saving the Configuration Changes

After users make changes to the configuration, pressing Update button will save but not apply the changes until Apply button is
clicked. Users can instead directly press Apply button. When a reboot is required to apply changes, the web page will prompt the user
to reboot by offering a reboot button on the web page.
Changing Admin Level Password
1. Access your HT818 web UI by entering its IP address in your favorite browser. (the screenshot is taken from an HT80X model since
the same configuration applies to the HT818 model)
2. Enter your admin password (default: admin).
3. Press Login to access your settings.
4. Go to Advanced Settings
5. Confirm the new admin password.
6. Press Apply at the bottom of the page to save your new settings.
Changing User Level Password
Username Password
user 123
admin admin
viewer viewer
�� New Admin Password and enter the new admin password.
Figure 5: Admin Level Password
Web Pages Allowed
Only Status and Basic Settings
All pages
View all pages. No changes allowed.