Basic Menu Operations (Main Menu, Setup Menu) - JVC DT-V1910CG Instructions Manual

PREPARATION
(cont'd)
ATTACHING THE POWER CORD HOLDER
•
The provided Power Cord Holder prevents accidental disconnection of the AC power cord from the AC inlet.
•
The Power Cord Holder consists of two parts; a case and cover.
1. Attach the Power Cord Holder case to the AC inlet on the back of the monitor with 2 screws
(provided).
2. Attach the Power Cord Holder cover to the AC power cord.
3. Connect the AC power cord to the AC inlet, and join the Power Cord Holder cover with the
case.
Caution:
•
A different plug shape will result in the cover being
attached to a different position.
•
Check to make sure the plug doesn't pull out after the
cover is attached.
10
Caution:
Use only the provided screws.
Press the cover until it clicks.
Hold until it clicks.
Note:
To disconnect the power cord, click the tab to open the
cover.
BASIC MENU OPERATIONS
(MAIN MENU, SETUP MENU)
ABOUT MENU SCREENS
This monitor features a MAIN MENU (main menu screen) and a SETUP MENU (setup menu screen).
The MAIN MENU contains the functions normally used, and the SETUP MENU contains the settings required for initial setup.
"MAIN MENU"
Items Functions
1 APERTURE CONTROL Compensates the frequency characteristics of the input video signal.
2 SLOT CONDITION Displays the status of the input cards installed in each of the input card slots.
3 sub menu POSITION Selects the display position of the sub menu superimposed on the screen.
4 AREA MARKER Controls ON/OFF and other settings of the MARKER, SAFETY MARKER,
and ZOOM functions included in the AREA MARKER function.
5 COLOR MATRIX Selects or adjusts the picture color matrix.
About "Displays" 1 : Not displayed when an RGB signal is input.
2 : Displayed only when the screen ratio is 16:9. Not displayed when an RGB signal is input.
When some items are not displayed depending on the input signals, subsequent items will move up.
Position of the menu varies depending on the type of signal.
"SETUP MENU"
Items Functions
1 FUNCTION SETTING Selects the control systems for the COLOR SYSTEM, synchronized signal, RUSH DELAY TIME,
tally lamp colors, and MAKE/TRIGGER terminal.
* Checks the amount of time that the monitor has been used.
* Sets the AUTO INPUT function ON/OFF. (When an input card compliant with AUTO INPUT is
installed.)
* Selects the audio channel group for the EMBEDDED AUDIO. (When an input card compliant
with EMBEDDED AUDIO is installed.)
2 PICTURE SUB ADJ. Controls the approximate adjustment of the video control level when the video adjustment knob is
adjusted to the center.
* Can also be used to switch the NTSC set-up level, and change the component signal's input level settings.
3 COLOR TEMP./BAL. Sets or adjusts the color temperature or white balance.
4 SIZE/POSI. ADJ. Adjusts the size or position of the picture.
5 DISTORTION ADJ. Compensates the picture distortion.
6 STATUS DISPLAY Sets the status display ON/OFF.
* Switches the display on and off. Also selects the type of display. (When an input card compliant with AUDIO LEVEL METER
is installed.)
* Switches the AUDIO PLL setting. (When SDI input card compliant with EMBEDDED AUDIO is installed.)
7 CONTROL LOCK Sets the control lock preventing the monitor from misuse.
8 all reset Sets all items in SETUP MENU to factory-preset values.
BUTTONS FOR MENU OPERATIONS
MUTING DEGAUSS UNDER SCAN CROSS PULSE COLOR OFF SLOT 1 SLOT 2 SLOT 3 POWER
A B C D E F
VOLUME MENU CHECK SCREENS ASPECT MARKER AREA INPUT SELECT
Displays
1
2
1
MUTING DEGAUSS
MENU
MENU
VOLUME
11