Lithium Ion Storage Battery-1 - Sony NW-ZX300 Service Manual

NW-ZX300/ZX300A
2-5.

LITHIUM ION STORAGE BATTERY-1

• Continued on 2-6 (page 19).
Note 1: When wire of the battery assy is removed from board, insulate
the end of battery wire by a tape etc. to prevent short-circuited
of the battery wire part of the battery assy.
1 screw M1.4
top side
front side
bottom side
front side
7 Remove the solder of
the battery wire [white].
Note 2: Perform insulation such as
taping the battery wire ends.
18
2 rear spacer (top) block
bottom side
5 Remove the solder of the
MAIN board wire [white].
3 Remove the solder of the
MAIN board wire [black].
4 Remove the solder of
the battery wire [black].
Note 2: Perform insulation such as
top side
6 Remove the solder of
the battery wire [red].
Note 2: Perform insulation such as
taping the battery wire ends.
8 Remove the solder
of the battery sheet.
battery assy
2 Soldering the
middle:
taping the battery wire ends.
[HP BTL wire]
7 Pass the MAIN board wire
outside:
[white]
1 Soldering the
Push.
battery sheet.
top side
3 Soldering the
battery wire
battery wire
[white].
[red].
4 Soldering the
MAIN board
wire [white].
5 Soldering the
6 Soldering the
[white] beside the rib.
inside:
[black]
rib
MAIN
board
upper:
[red]
lower:
[white]
battery wire
[black].
MAIN board
wire [black].