Sony NW-ZX300 Service Manual page 9

2-4. Pre-installed contents settings
Write the pre-installed contents.
Perform after each checks/settings.
Used tool (folder name):
Pre-installed contents
NWZX300_Contents_WW_V1.00.00 (Except CH)
NWZX300_Contents_CN_V1.00.00 (CH)
Transfer tool
NWZX300_opt3_transfer_tool_V1.00.00
Procedure:
1. Connect the WALKMAN main unit to PC (personal computer)
by the USB cable (WM-PORT).
(The power supply of the WALKMAN is automatically turned
on)
Note 1: If leave the connection status in the previous step, this step is not
necessary.
– Step 2 through step 15 will operate on the PC (personal com-
puter) –
2. Check how the WALKMAN is recognized by MSC connec-
tion, and the check of the drive letter is necessary.
(at this example, it is "F:")
3. Open the folder that the pre-installed contents and open the
WALKMAN storage.
4. Copy the "opt3" folder in the pre-installed contents folder to
the under root directory of the WALKMAN storage.
In the folder of
pre-installed contents
5. Open the folder that the transfer tool.
6. In the non-selected state for fi les in the folder, and put a cursor
to blank space in the folder.
In the folder of the transfer tool
7. The right-click while pressing the Shift key in the state of step
6.
USB cable
drive letter
Under root directory of
WALKMAN storage
Copy here
blank space
cursor
8. Select the "Open command window here" from the displayed
menu, and launch the command prompt application software.
9. Input the following command and press the Enter key.
"updating.bat f:"
("f:" is drive letter of checked at step 2)
C:\NWZX300_opt3_transfer_tool_V1.00.00>updating.bat f:
10. Check that the following fi gure message has been displayed,
and input "y", and press the Enter key.
(Using 2-byte characters, it may not be displayed correctly)
Input
The firmware update tool has booted.
The firmware of drive f: will be updated.
After the new firmware is copied to drive f:
the new firmware will be loaded and the unit will reboot.
Close SonicStage before starting this program.
Run this program? (y/n)
11. The following fi gure message is displayed, and the pre-in-
stalled contents settings is performed on the WALKMAN main
unit.
(Using 2-byte characters, it may not be displayed correctly)
C:\NWZX300_opt3_transfer_tool_V1.00.00>_
Firmware update will start.
Copying the new firmware image [NW_WM_FW.UPG]...
Copying NW_WM_FW.UPG...
1 file(s) copied.
Ready to start fupdate SCSI command !
execscsitest f: "0xfc 0 0x04 0x64 0x62 0x6d 0x6e 0 0 0 0 0"
Firmware update has started.
The firmware update tool will close.
12. The WALKMAN main unit reboots automatically after the
pre-installed contents settings is performed.
NW-ZX300/ZX300A
Input
– Continued on next page –
9