Epson Endeavor P60 User Manual page 88

You see the following menu:
S e t P o w e r - U p C o n f i g u r a t i o n
M o n i t o r T y p e
Power-Up Video Mode
VGA Memory Size
If the configuration shown is correct for your system, press FIO
to save the configuration and return to the Main Selection
Menu.
If you need to change any of the settings, follow these steps:
1. Select Monitor Type. You see a list of supported
monitors, as shown on page 6-4.
If your monitor is not in this list, check your monitor
documentation to see if its characteristics match one of the
listed types. If so, select that type and go to step 3.
If your monitor does not match any of these types, you can
set up a custom monitor. Go to step 2.
2. Select Custom from the monitor list. You see a list of
resolutions. You need to select the correct refresh rate (in
Hertz) that your monitor uses for each of the resolutions.
Check your monitor documentation for the correct refresh
rates.
Caution
You must select the correct refresh rates for each
resolution, or you could damage your monitor. Check
your monitor manual carefully as you select these rates.
: V G A o r P S / 2 c o l o r
: VGA (CVSO)
: Shared
Using the Video Utilities 6-9