Epson Endeavor P60 User Manual page 43

Some copy-protected programs require the computer to run at
low speed while accessing the program on a diskette. These
programs also usually require you to leave a key disk-the
diskette that contains the copy protection-in the diskette
drive. If you use a copy-protected program, you can change the
speed to low to access the diskette and return it to high speed
when you are finished.
You can change the processor speed temporarily by entering
one of the following commands from the numeric keypad on
your keyboard :
beep.
To select high speed, press Ctrl Alt +. You hear a high-toned
beep.
Note
You can use the commands listed above while you are
running a program. However, if the program uses one of
these commands for another function, you cannot use it to
change the processor speed.
The speed setting remains in effect until you do one of the
following:
Turn off your computer
Change the speed with another keyboard command.
3-4
Using Your Computer