Miscellaneous Problems - Epson Endeavor P60 User Manual

Miscellaneous Problems

Contact your Authorized EPSON Servicer or the EPSON
Connection if the suggested actions in the table below do not
solve the problem.
Problem
Application
software problems
Beep pattern is
absent
7-12
Troubleshooting
Solutions
Make sure all cables are installed correctly.
Verify that the system board jumpers are set properly.
Verify that your system hardware configuration is set
correctly. In Setup, check the values against the
system settings you recorded previously. If an error is
evident (wrong type of drive specified, for example),
make the change in Setup and reboot the system.
Record your change.
Make sure the software is properly configured for the
system. Refer to the software documentation for
information.
Try a different copy of the software to see if the
problem is with the copy you are using.
Try running the software at a different speed. See
Chapter 3.
If other software runs correctly on the system,
contact the vendor of the software that fails.
If you check all of the above with no success, try
clearing CMOS RAM (Chapter 4) and run Setup
(Chapter 2). Make sure you have your list of system
settings available to re-enter, because clearing
CMOS RAM sets the options to their default values.
If the system operates normally but there was no
beep, the speaker may be disabled or has failed.
Check that the speaker is enabled in Setup.