Figure 3-1: Initial Screen - DTK Apex 386/33 User Manual

If you reconfigure your system, you will need to enter the setup
program. When you restart the system, press the <ESC> key quickly
just after the RAM test. If you miss the chance to do so, press the
hardware reset switch, or just press the software reset switch
<Alt> and
setup program appears, the following message will be shown on the
screen:
When the RAM test is completed, the SETUP program will take over.
Once you have entered the SETUP program, you will see the following
initial screen:

Figure 3-1: Initial Screen

4 Chapter 3: Operating Your System
simultaneously to enter the setup program. Before the
<Del>
SETUP utility will be starting
ROM SETUP PROGRAM VERSION 1.02
(C) COPYRIGHT DATATECH ENTERPRISES CO., LTD 1988.
1. SET UP SYSTEM CONFIGURATION.
2. PREFORMAT HARD DISK.
3. SET UP BUILT-IN UTILITY.
4. SET UP PASSWORD.
5. SET UP USER-DEFINED HARD DISK TYPE.
9. QUIT SETUP PROGRAM.
CHOOSE ITEM NUMBER : [ ]
<Ctrl>,