Connecting The Printer To Your Computer; Connecting The Parallel Interface Cable - Epson FX-1050 User Manual

Part of a typical self test in NLQ mode is shown below:
3. To end the self test, press the ON LINE button to take the printer off
line. Then press the LOAD/EJECT button to eject the paper, and turn
off the printer.

Connecting the Printer to Your Computer

If the self test printed correctly and your printout looked like the one
shown, you are now ready to connect your printer to the computer.
Your FX printer has a Centronick®-compatible parallel interface. If you
have a suitable shielded cable, you should be able to connect your
printer immediately If your computer requires the use of another type of
interface, you need to install an optional interface board.
If you are unsure whether your computer has a parallel interface, see
your computer's operating manual. If the computer cannot use a parallel
interface, see the section on interface boards in Chapter 7.

Connecting the parallel interface cable

Connect the parallel interface cable as described below:
1. Turn off both the printer and your computer.
1-18 Setting Up the Printer