Trane SYMBIO 700 Troubleshooting Manual page 119

If using a mobile device to complete the Symbio 700 firmware update:
Place the downloaded Symbio 700 Firmware for Odyssey products onto a USB mass storage device. The
USB drive should be formatted as FAT32.
Using a Bluetooth enabled mobile phone, download the Symbio Service & Installation mobile app from
the appropriate app store.
Install the USB mass storage device into the USB Host connector in the top left corner of the Symbio 700
controller.
Power up the Symbio 700 controller.
After the Symbio Service & Installation app has been installed, reference the Symbio Service &
Installation Quick Start Guide (BAS-SVN043*) for instructions on how to pair the mobile phone with the
Symbio 700 controller.
After a connection has been established, initiate the firmware update process using the Symbio Service
& Installation App.
Navigate to the "Tools" menu of the mobile app.
Select the "Update Firmware" process
Navigate to the appropriate firmware file that is located on the USB mass storage device and select it.
Confirm the Firmware Update to initiate the process
NOTE: The Firmware Update process may take 3-5 minutes once initiated.
After the firmware update has been completed, power down the system and remove the USB mass
storage device.
119