RX350_270_EE_48D77E.book 225 ページ 2014年1月24日 金曜日 午前10時4分
Raindrop sensor
■
If the wiper switch is turned to the
●
STOP" switch is in IGNITION ON mode, the wipers will operate once to show
that AUTO mode is activated.
When the sensor sensitivity ring is turned toward high while in AUTO mode, the
●
wipers will operate once to indicate that the sensor sensitivity is enhanced.
If the temperature of the raindrop sensor is 90°C (194°F) or higher, or -15°C
●
(5°F) or lower, automatic operation may not occur. In this case, operate the wip-
ers in any mode other than AUTO.
If no windshield washer fluid sprays
■
Check that the washer nozzles are not blocked if there is washer fluid in the wind-
shield washer fluid reservoir.
CAUTION
Caution regarding the use of windshield wipers in AUTO mode
■
The windshield wipers may operate unexpectedly if the sensor is touched or the
windshield is subject to vibration in AUTO mode. Take care that your fingers etc. do
not become caught in the windshield wipers.
Caution regarding the use of washer fluid
■
When it is cold, do not use the washer fluid until the windshield becomes warm. The
fluid may freeze on the windshield and cause low visibility. This may lead to an acci-
dent, resulting in death or serious injury.
RX350/270_EE
2-3. Operating the lights and windshield wipers
The raindrop sensor judges the amount
●
of raindrops.
An optical sensor is adopted. It may not
operate properly when sunlight from the
rising or setting of the sun intermittently
strikes the windshield, or if bugs etc. are
present on the windshield.
position while the "ENGINE START
2
225