Omron V330-F Series Connection Manual page 78

Timeout Error/TCP Connection Status Error

The timeout error codes for open processing, send processing, and receive processing are set
in H400, H401, and H402, respectively. The timeout error code/TCP connection status error code
for close processing is set in H404.
(O: Open processing, S: Send processing, R: Receive processing, C: Close processing, ○: Applicable processing)
Error code O
0000 ○
F101 ○
F201
F301
F401
F402
FFFF ○
Code Reader Error Code

The error codes of code reader errors detected in receive processing are set in H403.
(O: Open processing, S: Send processing, R: Receive processing, C: Close processing, ○: Applicable processing)
Error code O
0000
F302
FFFF
* "ER" is the only error response supported for communications errors. For details, check the monitor
information on the code reader.
S R C
○ ○ ○ Normal end
Open processing not completed within specified time
Send processing not completed within specified time
○ (This includes cases where response to be received was not
received.)
○ Receive processing not completed within specified time
○ Close processing not completed within specified time
Normal TCP connection status not shown within specified time
○
after close processing
○ ○ ○ Processing skipped for some reason
S R C
○ Normal end
○ Response from code reader is "ER"
Judgment of code reader error not made due to no response from
○
code reader for some reason
9. Software Part
Description
Description
78