Omron V330-F Series Connection Manual page 26

7.3.3. Creating the I/O Table
Create the I/O table for the PLC.
If the PLC Operating Mode is
1
set to either Run or Monitor,
follow steps (1) to (3) to change
it to Program.
(1) In the CX-Programmer,
select Operating Mode –
Program from the PLC Menu.
(2) A dialog box as shown in the
figure on the right appears.
Click Yes.
For information on how the
dialog box is displayed, refer
to Note on the previous page.
(3) Confirm that Program Mode
is displayed to the right of the
PLC model
Programmer's project tree.
(See the figure on the right.)
In the CX-Programmer, select
2
Edit – I/O Table and Unit Setup
from the PLC Menu.
The PLC IO Table Window is
displayed.
in the CX-
7. Connection Procedure
26