If the WebLink startup screen does not appear, it means that communications are not
7
established between the code reader and the PC. Please check the following.
・ The code reader and the PC have a proper physical (cable) connection.
→ Refer to steps 1 and 2 to check the connection.
・ The IP Addresses of the PC and code reader are set correctly.
→ Refer to step 4 for setting the IP address of the PC.
For other measures that can be taken, please refer to When unable to access by WebLink in
Q&A in Appendices of the MicroHAWK V320-F/V330-F/V420-F/V430-F Series Barcode
Reader User Manual (Cat. No. Z432).
The WebLink screen appears.
8
Click on the Setup Tab and, in
9
Read Cycle Sequence, set
Cycle to Triggered.
10
Click on the gear icon on the
upper right of the screen and
select Advanced.
7. Connection Procedure
17