Installing The Left Control Panel - Dell PowerEdge R760 Installation And Service Manual

NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 255. Removing the left control panel
Next steps
1. Replace the left control

Installing the left control panel

Prerequisites
1. Follow the safety guidelines listed in the
2. Follow the procedure listed in the
3. Remove the drive backplane
4. If installed, remove the air shroud
5. Remove the cooling fan cage
6. Remove the side wall
Steps
1. Align and slide the left control panel in the slot on the system.
2. Route the left control panel cable through the side wall of the system.
3. Align and slide the left control panel cable cover in the slot on the system.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
4. Connect the left control panel cable to the connector on the system board .
5. Using the Phillips #1 screwdriver, tighten the screws to secure the left control panel and the cable cover to the system.
NOTE: The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
304 Installing and removing system components
panel.
Safety
Before working inside your
cover.
or remove the GPU air
assembly.
bracket.
instructions.
system.
shroud.