5. Close the expansion card retention latch.
6. Push the card holder to hold the module in the riser.
NOTE:
The numbers on the image do not depict the exact steps. The numbers are for representation of sequence.
Figure 132. Installing the APERC module
Next steps
1. Connect the cables to the APERC module and route the cables properly.
NOTE:
Refer to
cable routing
2.
Install the cooling fan cage
3. If removed,
install the air shroud
4.
Install the drive backplane
5.
Install the expansion card
6. Follow the procedure listed in
System memory
System memory guidelines
The PowerEdge R760 system supports DDR5 registered DIMMs (RDIMMs).
Your system memory is organized into eight channels per processor (two memory sockets per channel), 16 memory sockets per
processor and 32 memory sockets per system.
section for more information.
assembly.
or
install the GPU air
cover.
riser.
After working inside your
shroud.
system.
Installing and removing system components
177