Figure 77. Configuration 1: 12 x 3.5-inch SAS/SATA with APERC in Riser 2
NOTE:
Follow the sequential order as shown in the table to remove the cables, to install the cables follow the reverse
sequential order.
Table 80. 12 x 3.5-inch SAS/SATA with APERC in Riser 2
Order
From
1
SIG_PWR_1 (system board power connector)
2
CTRL_SRC_SA1_PA1 (adapter PERC controller
connector)
3
CTRL_SRC_SB1_PB1 (adapter PERC controller
connector)
124
Installing and removing system components
To
BP_PWR_1 (backplane power connector)
BP_DST_SA1 (backplane signal connector)
BP_DST_SB1 (backplane signal connector)