Dell PowerEdge R760 Installation And Service Manual page 310

Table 154. Cooling fan and foam requirement matrix (continued)
System configuration
16 x 2.5-inch NVMe
24 x 2.5-inch SAS/SATA
16 x 2.5-inch SAS/SATA + 8 x 2.5-inch
NVMe
24 x 2.5-inch NVMe
NOTE: HPR GOLD fans also known as High performance Gold (VHP) fans.
NOTE: For more information about supported cooling fans matrix, see the
NOTE: 12 x 3.5-inch and rear drive configuration systems do not support GPU card.
2. Remove the air shroud.
3. Remove the processor and heat sink module
NOTE: All GPU cards require L-type heat sink and GPU shroud installed, irrespective of the length.
4. Install the processor on L-type heat sink and
5. Install the GPU air shroud.
6. Remove the GPU air shroud top
NOTE: The GPU air shroud top cover is part of the GPU air shroud.
7. Remove the GPU air shroud
8. Install the GPU into full length risers.
NOTE: See installing full length expansion card riser
NOTE: For information about riser slot location on the system board, see the
section.
9. If applicable, connect the power cables to the GPU. To know the connectors for GPU on the system board, see the
board jumpers and connectors
See the GPU power cable matrix to know about the requirement of cable for the GPU.
Table 155. GPU power cable matrix
Catego Supported GPUs
ry
GPU NVIDIA A2
GPU NVIDIA A30, A40, A16,
A100, and A800
GPU NVIDIA H100
310 Upgrade Kits
Cooling fan
w/GPU
HPR GOLD
HPR GOLD
HPR GOLD
HPR GOLD
and also
install the processor and heat sink
cover.
filler.
section.
Type
HL (FH and LP
brackets)
FH and FL
FH and FL
remove the processor.
into the system.
Vendor Cable
NVIDIA Not required
NVIDIA CPU type 2 x 4 (8-position)
NVIDIA 12VH type 2 x 6 + 1 x 4 (12-
position + 4-sideband)
Foam requirement
w/GPU
No
Yes
Yes
No
thermal restriction matrix
module.
System board jumpers and connectors
Cable quantity
Not required
1 each for Riser 1
and Riser 4
1 each for Riser 1
and Riser 4
section.
System