Configuring received numbers
The Public Received number length and the Private Received number length (refer to
parameters" on page
The retained digits are mapped to the DN using fields provided on the Target Lines panel. (For
more information on target lines, refer to
To map received numbers to the DN
1
In Element Manager, navigate to Configuration > Telephony > Lines > Target Lines (see
Figure
10).
2
Select the target line of the DN for which you want to configure the received numbers.
3
In the Details for Line subpanel, select the Parameters tab.
4
In the Pub. Received # field, enter the retained received digits for calls originating from the
PSTN.
5
In the Priv. Received # field, enter the retained received digits for calls originating from the
private network (that is, the VoIP trunks). This number is usually the same as the DN.
Figure 10 Target Lines panel
65) determine the number of digits that the SRG retains for call processing.
Note: If the retained digits are the same as the DN, the fields (Pub.
Received # field and Priv. Received # field) can be left blank.
Chapter 5 Setting up IP telephones
"SRG200/400 Release 1.5 terminology" on page
SRG200/400 Release 1.5 Configuration Guide
57
"Basic
18).