Close SIM card holder door and slide downuntil it is securely in place.
7.
Close rubber access door.
8.
Installing the Battery
NOTE The MC55 ships with a 2400 mAh battery. An optional 3600 mAh battery is available.
It is not required to remove the handstrap when installing the battery.
To install the battery.
Insert the battery, bottom first, into the battery compartment in the back of the MC55.
1.
Press the battery down into the battery compartment until the battery release latch snaps into place.
2.
Inserting the Battery
Figure 1-5
The MC55 powers up automatically after inserting the battery if the battery has been charged previously.
Charging the Battery
CAUTION
Ensure that you follow the guidelines for battery safety described in
Charging the Main Battery
Before using the MC55 for the first time, charge the main battery until the amber Charging/Battery Status LED
remains lit (see
Table 1-2 on page 1-6
with the appropriate power supply. For information about the accessories available for the MC55, see
Accessories.
For cable and cradle setup and charging procedures refer to the MC55 Integrator Guide.
•
USB Charging Cable
•
Charge Only Cable
Battery Release Latch
2
1
for charge status indications). To charge the MC55, use a cable or a cradle
Getting Started
Battery
Battery Safety Guidelines on page
Chapter 4,
1 - 5
5-2.