Electronic Cruise Control - Fiat 500 Manual

NOTE It is advisable to decelerate
to a speed at least 5 km/h below
that programmed limit. Otherwise,
the acoustic warning may activate to
warn that the speed limit has been
exceeded.
FLASHING OF
PROGRAMMED SPEED
The programmed speed flashes in the
following cases:
when the accelerator pedal has
been fully depressed and the car has
exceeded the programmed speed;
activating the system after setting a
limit below the effective vehicle speed
(with acoustic warning);
when the device cannot reduce the
vehicle speed due to the gradient of the
road (with acoustic warning);
in the event of sharp acceleration.
DEACTIVATING THE
DEVICE
To activate the device, turn ring (C)
fig. 132 to position 0.
Automatic off of the device
The device deactivates automatically in
the event of fault in the system. In this
case, contact a Fiat Dealership.
AUTOMATIC RESET OF
THE PROGRAMMED
SPEED
With the Speed Limiter enabled,
pressing button (A) (CANC/RES)
fig. 132 at a higher speed than the
set value, the engine torque will be
reduced as required to reach that
value, if it was not reached within 20
seconds from pressing the button.
ELECTRONIC
CRUISE CONTROL
(for versions/markets, where provided)
This is an electronically controlled
driving assistance device that
allows the desired car speed to be
maintained, without having to press the
accelerator pedal.
This device can be used at a speed
above 30 km/h on long stretches of
dry, straight roads with few variations
(e.g. motorways).
It is therefore not recommended to use
this device on extra-urban roads with
traffic. Do not use the device in town.
ACTIVATING THE DEVICE
142) 143) 144)
To activate the device, turn ring (C)
fig. 135 to position . The
comes on to indicate that the device
has been activated (versions with
multifunction display: fig. 136, versions
with colour display: fig. 137).
The device cannot be engaged in
1 st or reverse gear: it is advisable to
engage it in 3 rd gear or higher.
135
136
symbol
F0S0624
F0S0628
135