Maintaining The Qos Agent; Qos Agent Reset-Default Command; Qos Agent Nvram-Delay Command; Default Qos Agent Nvram-Delay - Nortel 4524GT Configuration

72 Chapter 2 Configuring Quality of Service (QoS) with the CLI
The no qos policy command is executed in the Global Configuration
command mode.

Maintaining the QoS Agent

The following commands allow for the maintenance of the QoS agent .

qos agent reset-default command

The qos agent reset-default command deletes all user-defined
entries, removes all installed policies, and resets the system to its QoS
factory default values.
The syntax for the qos agent reset-default command is
qos agent reset-default
The qos agent reset-default command is executed in the Global
Configuration command mode.

qos agent nvram-delay command

The qos agent nvram-delay command specifies the maximum amount
of time, in seconds, before non-volatile QoS configuration is written to
non-volatile storage. Delaying NVRAM access can be used to minimize file
input and output. This can aid QoS agent efficiency if a large amount of
QoS data is being configured.
The syntax for the qos agent nvram-delay command is
qos agent nvram-delay <0-604800>
Substitute <0-604800> above with the maximum amount of time (in
seconds) before non-volatile QoS configuration data is written to non-volatile
storage. The default is 10 seconds.
The qos agent nvram-delay command is executed in the Global
Configuration command mode.

default qos agent nvram-delay

The default qos agent nvram-delay command resets the NVRAM
delay time to factory default.
The syntax for the default qos agent nvram-delay command is
default qos agent nvram-delay
The default qos agent nvram-delay command is executed in the
Global Configuration command mode.
Copyright © 2007, Nortel Networks
.

Nortel Ethernet Routing Switch 4500 Series

Configuration — Quality of Service
NN47205-504 (322816-B)
5.1 23 November 2007
03.01 Standard