Wiring The Power Inputs - Planet IECC-210T User Manual

100BASE-TX RJ45 Port (Port Input/Port Output)
LED Color
Light
LNK/
Green Blinking
ACT
Off
100BASE-FX SFP Port (Port Input/Port Output)
LED Color
Light
LNK/
Green Blinking
ACT
Off

4.2 Wiring the Power Inputs

The 4-contact terminal block connector on the top panel of Industrial EtherCAT
Media Converter module is used for one DC power input. Please follow the
steps below to insert the power wire.
When performing any of the procedures like inserting the wires
or tightening the wire-clamp screws, make sure the power is
OFF to prevent from getting an electric shock.
1. Insert positive and negative DC power wires into contacts 1 and 2 for
POWER.
8
Indicating that the port is linked up.
Indicating that the module is actively sending or
receiving data over that port.
Indicating that the port is linked down.
Indicating that the port is linked up.
Indicating that the module is actively sending or
receiving data over that port.
Indicating that the port is linked down.
1 2 3 4
V1+ V2+
PWR1 PWR2
Figure 3: IECS-210T/IECC-210R Top View
Function
Function
DC Input:
9-48V , 0.6A max.