Table of Contents
Advertisement
Machine Operation (Cont.)
Symptom
Possible Cause
Will not make
1. 90° stop out of adjustment.
accurate square
cuts.
Blade tilt does
1. 45°/90° stop out of adjustment. Sawdust built
not stop at
up in/on trunnions.
45°/90°.
Blade will not go
1. Roll pin/set screw in worm gear contacting
beneath table
geared trunnion.
surface.
2. Debris lodged between trunnion castings.
Blade will not
1. Set screw on worm gear is loose or missing.
move up or
down.
Fence contacts
1. Wing not flush with table.
wings as it slides
over.
Tilt scale shows
1. Pointer not calibrated correctly to scale.
inaccurate
reading.
Workpiece
1. Table insert not adjusted properly.
catches on table
insert or table
opening during
cutting operation.
Rip fence
1. Rip fence mounted/adjusted incorrectly.
does not move
smoothly.
2. Rails dirty or sticky.
-66-
Possible Solution
1. Adjust 90° stop (Page 67).
1. Adjust 45°/90° stop (Page 67). Remove sawdust
from trunnions. Clean and re-lubricate as
necessary.
1. Tighten roll pins and set screws in the worm gear.
2. Remove debris.
1. Tighten or replace set screw.
1. Make wing flush with table.
1. Adjust blade 90° to table using a square, then
calibrate pointer to scale (Page 67).
1. Adjust table insert so it is perfectly flush with table
surface (Page 76).
1. Remount rip fence. Adjust fence to ensure
adjustment screws are not too tight (Page 74).
2. Clean and wax rails.
Model G0962A40 (Mfd. Since 07/22)
Advertisement
Table of Contents
