Grizzly G0962A40 Owner's Manual page 49

Components Needed
Flat Hd Cap Screws M6-1 x (Length Varies) ...3–6
Hex Nuts M6-1 ...............................................3–6
Wood* ⁄ " x 4" x Length of Fence ......................1
3
4
*Only use furniture-grade plywood, kiln-dried
hardwood, or HDPE plastic to prevent warping.
To build an auxiliary fence:
1.
Cut auxiliary fence board to size. If you are
using hardwood, cut board oversize, then
joint and plane board to correct size to make
sure board is square and flat.
2.
Remove fence cap from fence face on which
you will mount auxiliary fence (see Figure 73).
Fence Cap
Lower T-Slot
Figure 73. Auxiliary fence mounts on upper or
lower T-slots of fence face.
3.
Slide (3) M6-1 hex nuts into either the upper
or lower T-slot.
Note: For additional mounting strength,
attach auxiliary board with (6) hex nuts and
flat head cap screws using upper and lower
T-slots.
Model G0962A40 (Mfd. Since 07/22)
Upper T-Slot
4. Place auxiliary fence board against fence
face. Place a thin metal shim (such as a ruler)
between table and bottom of auxiliary fence
board to ensure adequate clearance between
fence board and table. Clamp in position.
5.
Measure depth of board plus depth of T-slot,
to determine maximum length of M6-1 flat
head cap screws needed to mount auxiliary
fence board to fence face.
6.
Measure centerline of fence T-slot and trans-
fer to auxiliary fence board to determine
where to drill holes in board for flat head cap
screws.
7.
Set auxiliary fence board aside, and using
⁄ " drill bit, drill mounting holes in auxiliary
1
4
fence board. Countersink holes
head of cap screw sits slightly beneath face
of auxiliary fence board.
8.
Insert cap screws through holes in auxiliary
fence board (see Figure 74).
9.
Align cap screw threads with hex nuts and
tighten (see Figure 74).
x 3
Figure 74. Example auxiliary fence attached to
included fence.
10. Re-install fence cap.
⁄ " deep so
1
16
-47-