Table of Contents
Advertisement
8.
Plug in table saw, turn it ON, and use a push
stick or push block to feed workpiece through
blade, using a slow and steady feed rate.
Note: We recommend making a series of
light cuts that get progressively deeper, to
reduce the chance of stalling the motor.
The danger of kickback increases relative to
the depth of a cut. Reduce the risk of kick-
back by making multiple passes to achieve
the desired depth of cut. Failure to follow
these warnings could result in serious per-
sonal injury.
9.
Flip workpiece end-over-end, keeping same
side against fence, and run workpiece through
blade.
Model G0962A40 (Mfd. Since 07/22)
10. Repeat Steps 7–9 until blade is close to half
the height of board to be resawn. The ideal
completed resaw cut will leave a
tion when resawing is complete, as shown
in Figure 76. Leaving a
reduce risk of kickback.
Workpiece
Resaw
Barrier
/
" Connection
1
8
Figure 76. Ideal completed resaw cut.
11. Turn OFF table saw, then separate parts of
workpiece and hand plane remaining ridge to
remove it.
12. When finished resawing, remove resaw bar-
rier and auxiliary fence, then re-install blade
guard/spreader or riving knife and standard
table insert.
⁄
" connec-
1
8
⁄
" connection will
1
8
Auxiliary
Fence
Fence
-49-
Advertisement
Table of Contents
