Grizzly G0962A40 Owner's Manual page 27

16. Install saw blade as instructed in Blade
Installation on Page 34.
17. Install table insert in table opening (see
Figure 26). Check to make sure it is flush
and adjust if necessary (see Table/Dado
Insert Adjustment on Page 76).
Figure 26. Standard table insert installed.
18. Place fence on front fence rail, as shown in
Figure 27. Press handle down to lock fence
in position.
Front
Fence
Rail
Figure 27. Fence installed on front rail.
Model G0962A40 (Mfd. Since 07/22)
19. Using blade height handwheel, raise blade
1–2 inches.
20. Turn blade tilt handwheel until blade tilt
indicator on front of machine points to 0° on
blade angle scale.
21. Lift fence handle and slide fence so it lightly
touches right side of blade (see Figure 28).
Do not lock fence at this time.
22. Nudge fence rail so zero mark of scale (on
right) lines up with cross-hair in fence scale
window (see Figure 28).
Fence
23. Tighten hex nuts from Step 13 to secure front
fence rail.
Fence Lightly
Touching Blade
Figure 28. Fence scale calibration.
Fence Scale
Window
-25-