Grizzly G0962A40 Owner's Manual page 48

Making Resaw Barrier
When resawing, the resaw barrier acts in tandem
with the rip fence to provide tall support for the
workpiece. This minimizes the probability of it
binding against the blade and causing kickback.
Tools Needed
Table Saw .......................................................... 1
Jointer and Planer .......................Recommended
Clamps ............................................ 2 (Minimum)
Power Drill ......................................................... 1
Drill Bits ⁄ ", ⁄ " ..........................................1 Ea.
1 9
8 64
Countersink Bit .................................................. 1
Components Needed for Resaw Barrier
Wood* ⁄ " x 5 ⁄ " x Length of Fence .................. 1
3 1
4 2
Wood* ⁄ " x 3" x Length of Fence ..................... 1
3
4
Wood Screws #8 x 2" ........................................ 4
Wood Glue......................................... As Needed
*Only use furniture-grade plywood, kiln-dried
hardwood, or HDPE plastic to prevent warping.
To make a resaw barrier:
1. Cut your wood pieces to size specified above.
If you are using hardwood, cut pieces over-
size, then joint and plane them to correct size
to make sure they are square and flat.
2.
Pre-drill and countersink four holes approxi-
mately ⁄ " from bottom of 5
3
8
3.
Glue end of 3" board, clamp boards at a 90°
angle with larger board in vertical position, as
shown in Figure 71, then fasten together with
wood screws.
#8 x 2"
Wood Screw
⁄ "
3
4
Figure 71. Resaw barrier.
-46-
Qty
⁄ " tall wood piece.
1
2
⁄ "
3
4
Assembled
Resaw Barrier
Making Auxiliary Fence
An auxiliary fence is necessary if you are resawing
a workpiece that is taller than it is wide. The fence
should be no less than
to be resawn.
The fence should be similar to the one in Figure 72
when installed.
Auxiliary Fence
M6-1 Flat
Head Cap Screw
Assembled Auxiliary Fence
Figure 72. Example of auxiliary fence location.
Tools Needed
Clamps ...............................................................2
Power Drill ..........................................................1
Drill Bit ⁄ " ..........................................................1
1
4
Countersink Drill Bit ............................................1
Hex Wrench 5mm ...............................................1
Ruler ...................................................................1
Model G0962A40 (Mfd. Since 07/22)
⁄ " shorter than the board
1
2
M6-1 Hex Nut
Fence
Qty