Grizzly G0962A40 Owner's Manual page 24

5. Install handwheels on shafts, making sure
notch in each handwheel fits over pin on
each shaft, as shown in Figure 15, and then
secure with star knobs.
Notch
Figure 15. Handwheel properly installed.
6. Turn blade tilt handwheel until blade tilt indi-
cator points to 15° on blade angle scale (see
Figure 16).
Blade Tilt
Indicator
Figure 16. Blade tilt indicator and angle scale.
-22-
Star Knob
Blade Tilt
Handwheel
Blade Elevation
Handwheel
7. Inspect mating surfaces of cast iron table
for burrs or foreign material that may inhibit
installation of extension wings.
IMPORTANT: Mating edges of table and
wings must be clean, smooth, and flat. If
necessary, use a wire brush or file to remove
any flashing, dings, or high spots. This step
will ensure that wings will mount properly to
main table.
8.
With another person to hold wings in place,
attach each extension wing to main table
using (3) M10-1.5 x 25 cap screws, 10mm
lock washers, and 10mm flat washers (see
Figure 17).
Cap Screw
M10-1.5 x 25
Lock Washer
10mm
Flat Washer
10mm
Extension Wings
Figure 17. Extension wings installed.
Model G0962A40 (Mfd. Since 07/22)