Grizzly G0962A40 Owner's Manual page 58

Using Auxiliary Fence & Push Block
1.
Place auxiliary fence on table and clamp
it to fence at both ends, then adjust dis-
tance between auxiliary fence and blade—
this determines how wide workpiece will be
ripped (see Figure 92).
Auxilliary Fence
Blade
Workpiece
Cutting Width
Figure 92. Adjusting ripping distance between
blade and auxiliary fence.
2.
Install blade guard, then disable pawls, as
explained on Page 37, so they do not inter-
fere with push block lip.
Keep the blade guard installed and in the
down position. Failure to do this could
result in serious personal injury or death.
3. Place workpiece 1" behind blade and even-
ly against table and auxiliary fence (see
Figure 93).
-56-
Auxilliary Fence
Blade
Workpiece
Push Stick
for Side
Support
Blade Path
Figure 93. Push block in position to push
workpiece through blade.
4. Turn saw ON, then begin ripping workpiece
using a push stick for side support.
5. As workpiece nears end of cut, place push
block on auxiliary fence with lip directly
behind workpiece, then release push stick
just before blade.
6. Guide workpiece rest of way through cut with
push block, as shown in Figure 94.
Release
Push Stick
Before Blade
Lip
Blade Path
Figure 94. Ripping with push block.
Turn OFF the saw and allow blade to come
to a complete stop before removing cut-off
piece. Failure to follow this warning could
result in serious personal injury.
Model G0962A40 (Mfd. Since 07/22)
Push
Block
Push
Block