Grizzly G0962A40 Owner's Manual page 26

12. Re-install end cap and tap screw on fence rail
(see Figure 22).
Figure 22. Left end cap re-installed on front
fence rail.
13. Align (8) hex bolts in fence rail with holes
in table, then insert bolts into table. Be sure
scale on fence rail is facing up. Hand tighten
(8) M8-1.25 hex nuts onto hex bolts (see
Figure 23). Do not fully tighten fasteners at
this time.
Figure 23. Front fence rail mounted.
-24-
14. Install switch on hex bolts from Step 10 using
(2) M8-1.25 hex nuts and (2) 8mm lock wash-
ers (see Figure 24).
x 2
x 1
15. Install rear fence rail on rear of table using
(8) M8-1.25 x 25 cap screws, as shown in
Figure 25. Secure outer four cap screws with
M8-1.25 hex nuts.
x 2
Figure 25. Mounting rear fence rail.
Figure 24. Switch installed.
Rear Fence Rail
x 4
Model G0962A40 (Mfd. Since 07/22)
x 2