Table of Contents
Advertisement
9.
Place straightedge across extension wings
and main table to ensure combined table
surface is flat.
— If combined table surface is flat, skip to
next step.
— If outside end of extension wing tilts down,
remove wing and place a strip of masking
tape along bottom edge of main table to
shim end of wing up (see Figure 18).
— If outside end of extension wing tilts up,
remove wing and place a strip of mask-
ing tape along top edge of main table to
shim end of extension wing down (see
Figure 19).
Note: After re-installing wings, remove all
excess masking tape with a razor blade.
Figure 18. Masking tape location for tilting
extension wing up.
Figure 19. Masking tape location for tilting
extension wing down.
Model G0962A40 (Mfd. Since 07/22)
10. Remove (2) M8-1.25 x 16 hex bolts from
switch, then remove tap screw and end cap
from left end of front fence rail. Insert hex
bolts into bottom slot on left end of fence rail
(see Figure 20). These bolts will be used
later for mounting the switch.
x 2
Figure 20. Location of hex bolts for mounting
switch.
11. Orient fence rail so scale faces you. Slide (8)
M8-1.25 x 30 hex bolts into open slot (see
Figure 21).
Figure 21. Hex bolt positioned in front fence rail
slot.
x 8
Slot
Scale
-23-
Advertisement
Table of Contents
