Connecting The Device - Bosch WAN282A2 Use And Assembly Instructions

4.5 Connect the device
Connect the water inlet hose Notes
¡ Note the information
on the subject of security → page 4
and avoid property damage
→
Page 11, to keep your device safe
need to be able to.
¡ Make sure you do that
Connect the device to a water inlet
with a safety device against
drinking water contamination
through backflow (according to DIN
EN 1717). The connection valves /
water taps provided for this are
equipped with this safety device if
the building is properly installed.
Connect the water inlet hose to the
1.
device.
1
Connect the water inlet hose to the
2.
tap (26.4 mm = 3/4 ").
2
¾˝
min.
10mm
min.
17mm
Set up and connect de
Carefully open the tap and check
3.
whether the connection points are
tight.
Connection types water drain
The information will help you to
connect this device to the water drain.
Note: Note the information on
security
→
page 4 and avoid damage to property.
the → Page 11, to use your device
safely.
CAUTION!
When pumping out, the water
drainage hose is under pressure and
can come loose from the installed
connection point.
The water drain hose against
▶
Secure unintentional loosening.
Note: Note the pumping heights.
The pumping heights are: minimum:
60 cm, maximum: 100 cm
Expiration in a
sink
Expiration in a
Plastic pipe
with rubber sleeve. a bend
The connecting
pose with a
Hose clamp
(24-40 mm) si-
to cherish.
The water drainage
running hose with
a bend
→
Page 33 fixation
ren and secure.
The water drainage
running hose with
→
Page 33 fixation
ren and secure.
17th