Bosch WAN282A2 Use And Assembly Instructions page 52

de Troubleshooting
disturbance
"E: 36 / -25 / -26"
lights up.
flashes.
All other fault co-malfunction
of.
Device works
not.
Program starts
not.
52
Cause and troubleshooting
The drain pump is blocked.
→ " Cleaning the drain pump ", page 46
▶
Water pressure is low. No
fix possible.
The filters in the water inlet are blocked.
Clean the filters in the water inlet → Page 48.
▶
The tap is closed.
Open the faucet.
▶
The water inlet hose is kinked or pinched.
Make sure that the water inlet hose
▶
is not kinked or pinched.
Temperature is too high.
Wait until the temperature has dropped.
▶
→ " Abort program ", page 40
▶
The water level is too high.
Start the program Pumping out.
▶
Laundry is jammed in the door.
Open the door again.
1.
Remove jammed laundry.
2.
Close the door.
3.
To start the program, press Begin /
4th
Reload.
Door is not closed.
Close the door.
1.
To start the program, press Begin /
2.
Reload.
Call customer service.
▶
→
"Customer service", page 61
The mains plug of the mains connection cable is not
plugged in.
Connect the device to the mains.
▶
The fuse is defective.
Check the fuse in the fuse box.
▶
Power supply has failed.
Check whether the room lighting or other
▶
Devices in the room work.
Start / reload was not pressed.
Press Start / reload.
▶