Table of Contents
Advertisement
disturbance
Wrinkling.
Detergent or
Fabric softener is dripping from the drawer.
the cuff and
collects on the door
or in the cuff.
Spin result is
not satisfied-
lend. The laundry is
too wet / too damp.
Cause and troubleshooting
For the next wash cycle, reduce the load
▶
amount of manure.
The wrong program has been selected for the type of fabric.
Select programs suitable for the type of textile
▶
the end.
→ "Programs", page 26
Too much detergent / fabric softener in the detergent
When dispensing liquid detergents, please note
▶
tel and fabric softener mark the mark in the
detergent drawer and do not dose over it.
The low spin speed is set.
Set a higher one for the next wash cycle
▶
Spin speed.
Start the program Sling .
▶
The drain pipe or water drainage hose is blocked.
Clean the drain pipe and water drain
▶
running hose.
The drain pipe or water drainage hose is kinked or
pinched.
Make sure the drain pipe and the
▶
The water drainage hose is not kinked or trapped.
The unbalance control system has stopped spinning
due to uneven distribution of the laundry.
Redistribute the laundry in the drum.
▶
Note: Place large and small items of laundry together
in the drum. Laundry items of different sizes are
better distributed during spinning.
Start the program Sling .
▶
The unbalance control system compensates for unbalance
by reducing the spin speed.
Redistribute the laundry in the drum.
▶
Note: Place large and small items of laundry together
in the drum. Laundry items of different sizes are
better distributed during spinning.
Start the program Sling .
▶
Troubleshooting de
57
Advertisement
Table of Contents
