Samsung AC TNPPEH Series User & Installation Manual page 48

Installation Procedure
b Set the SEG24 value by pressing the
value you want to set appears on the remote control display.
When you press the
following order:
3 Check whether the option values that you have set are correct by pressing the
[SEG2, SEG3] [SEG4, SEG5]
[SEG14, SEG15] [SEG16, SEG17]
4 Save the option values into the indoor unit:
Point the remote control to the remote control sensor on the indoor unit and then press the
remote control twice. Make sure that this command is received by the indoor unit. When it is successfully received, you
can hear a short sound from the indoor unit. If the command is not received, press the
5 Check whether the air conditioner operates in accordance with the option values you have set:
a Reset the indoor or outdoor unit.
• Indoor unit : Press the
• Outdoor unit : Press the K3 button.
b Remove the batteries from the remote control, insert them again, and then press the
remote control.
Setting the indoor unit addresses
Option No. for an indoor unit address: 0AXXXX-1XXXXX-2XXXXX-3XXXXX
Before installing an indoor unit, be sure to set an address for the indoor unit by taking the following steps:
1 Make sure that the power is supplied to the
indoor unit. If the indoor unit is not plugged in, it
must include a power supply.
48
English
DB68-09343A-00_IBIM_PAC 미라지 이집트파키스탄_IQ_EN.indd 48
Steps
(High Fan) button repeatedly until the
(Low Fan) or (High Fan) button, values appear in the
[SEG6, SEG8] [SEG9, SEG10]
[SEG18, SEG20] [SEG21, SEG22]
(Set) and (Low Fan) buttons on the remote control simultaneously for 4 seconds.
(Mode) button repeatedly
[SEG11, SEG12]
[SEG23, SEG24]
Indoor Unit
1(L) 2(N)
Remote control display
SEG24
(Power) button on the
(Power) button again.
(Power) button on the
F1 F1
2020-07-28 오전 11:08:54