Step 11 Performing Drainage Test; Step 12 Connecting The Power And Communication Cables - Samsung AC TNPPEH Series User & Installation Manual

Installation Procedure
2 Insert the end of the drain hose to the extension drain
hose to make a connection.
3 Tightly wrap the connection part with a cable tie or tape
for fixing.
• When the hole of the drain hose on the wall is lower
than that of the drain hose connection
Indoor unit
• When the hole of the drain hose on the wall is higher
than that of the drain hose connection
Indoor unit
40
English
DB68-09343A-00_IBIM_PAC 미라지 이집트파키스탄_IQ_EN.indd 40
Drain hose
Drain hole for duct
(polypropylene)
Insulation
(foamed polyethylene)
Connecting drain hose
Inside indoor unit

Step 11 Performing drainage test

Put the water bottle deeply into the first blade on the left
of the air outlet and slowly pour water.
Water bottle
Step 12 Connecting the power and
communication cables
CAUTION
• Always remember to connect the refrigerant pipes before
performing the electric connections.
When disconnecting the system, always disconnect the
electric cables before disconnecting the refrigerant pipes.
• Always remember to connect the air conditioner to
the grounding system before performing the electric
connections. Use a crimp ring terminal at the end of
each wire.
The indoor unit is powered through the outdoor unit by
means of a H07 RN-F connection cable (or a more power
model), with insulation in synthetic rubber and a jacket
in polychloroprene (neoprene), in accordance with the
requirements specified in the standard EN 60335-2-40.
1 Remove the screw on the electrical component box and
remove the cover plate.
2 Route the cables through the sides or back of the
indoor unit and then connect them to the terminals
noting the figure below.
3 Route the other end of the cable to the outdoor unit
through the ceiling & the hole on the wall.
4 Reassemble the electrical component box cover,
carefully tightening the screw.
2020-07-28 오전 11:08:51