Table of Contents
Advertisement
Become familiar with the names and locations of the controls and features shown below to better understand
the instructions in this manual.
A
M
L
A. Reset Button: Allows machine to be restart-
ed after thermal overload protection has
tripped motor. To reset button, place ON/
OFF switch in OFF position, wait a few min-
utes for motor to cool, then press reset but-
ton. If button does not stay depressed, allow
motor to cool off longer, then try again.
B. Chuck Access Cover: Provides access to
chuck inside of headstock.
C. ON/OFF Switch: Starts and stops motor.
Yellow key can be removed to disable switch.
D. Hand Lever: Raises and lowers headstock.
E. Storage Rack: Stores chisels, hex wrench-
es, and extra drill chuck.
F.
Depth Stop: Limits depth headstock can
travel.
Model T33127 (Mfd. Since 10/21)
Identification
B
C
K
J
H
G. Fence Micro-Adjustment Bracket: Provides
H. Table: Supports workpiece.
I.
J.
K. Hold-Down: Holds workpiece down when
L.
M. Gas Spring: Supports headstock.
D
I
fine control of fence movement.
Chip Guard: Shields user from flying debris.
Fence: Moves to position workpiece under
chisel.
chisel is raised after mortising operation.
Fence Lock Handle: Locks fence. When
loosened, allows fence to move.
E
F
G
-3-
Advertisement
Table of Contents
