Steps
NOTE:
For models shipped with a scanner in the expansion bay at the top side of the tablet.
1. Connect the scanner FPC to the connector in the decoder daughter-board.
2. Align the screw holes on the decoder daughter-board with the screw holes on the system board.
3. Replace the two screws (M1x2.65) to secure the decoder daughter-board to the system board.
Next steps
1. Install the
back-cover
2. Install the batteries.
3. Install the
handle
(for models shipped with handle).
4. Install the stylus.
5. Follow the procedure in
World-facing camera
Removing the world-facing camera
Prerequisites
1. Follow the procedure in
2. Remove the stylus.
3. Remove the
handle
(for the models shipped with a handle).
4. Remove the batteries.
5. Remove the
back-cover
About this task
The figure indicates the location of the world-facing camera and provides a visual representation of the removal procedure.
assembly.
after working inside your
before working inside your
assembly.
tablet.
tablet.
Removing and installing components
53