Dell Latitude 7230 Service Manual page 30

Steps
1. Align and place the solid-state drive on the SSD carrier.
2. Align the screw hole on the SSD cap with screw hole on the SSD carrier.
3. Replace the single screw (M2x3) to secure the SSD cap to the SSD carrier and flip the solid-state drive assembly.
4. Using the pull tab, align the notch on the solid-state drive with the tab on the M.2 card slot.
5. Remove the single screw (M2x3) that secures the solid-state drive assembly in place.
6. Slide the SSD release latch into the lock position.
30 Removing and installing components