7. For models shipped with an M.2 SSD door, slide down and hold the SSD-door release latch and then place the SSD door
from the tablet.
8. For models shipped with an M.2 SSD door, replace the single screw (M2x2) to lock the SSD door release latch.
Next steps
1. Install the
back-cover assembly
2. Remove the
batteries
3. Remove the
handle
(for models shipped with/without an M.2 SSD door).
4. Follow the procedure in
5. Verify if the storage device is installed correctly:
a. Turn on or restart your computer.
b. Press F2 when the Dell logo is displayed on the screen to enter the system setup (BIOS) program.
NOTE:
A list of storage devices are displayed under the System Information in the General group.
c. If you have replaced the primary storage device that had the operating system installed, see Reinstall Windows 10 to
the Dell factory image using recovery media in the knowledge base article 000176966.
Wireless card
Removing the wireless card
Prerequisites
1. Follow the procedure in
2. Remove the stylus.
3. Remove the
handle
(for the models shipped with a handle).
4. Remove the batteries.
5. Remove the
back-cover
About this task
The figure indicates the location of the wireless card and provides a visual representation of the removal procedure.
(for models shipped without an M.2 SSD door).
(for models shipped without an M.2 SSD door).
after working inside your
before working inside your
assembly.
tablet.
tablet.
Removing and installing components
31