Fan And Ssd Heat-Sink Assembly; Removing The Fan With Ssd Heat-Sink - Dell Latitude 7230 Service Manual

Steps
1. Align the screw holes on the bracket with the screw holes on the tablet.
2. Replace the two screws (M2x3) to secure the front camera and microphone assembly to the tablet.
3. Connect the front-camera FPC or microphone FPC to the connector on the system board.
Next steps
1. Install the world-facing
2. Install the back-cover
3. Install the batteries.
4. Install the handle (for models shipped with handle).
5. Install the stylus.
6. Follow the procedure in

Fan and SSD heat-sink assembly

Removing the fan with SSD heat-sink

Prerequisites
1. Follow the procedure in
2. Remove the stylus.
3. Remove the handle (for the models shipped with a handle).
4. Remove the batteries.
5. Remove the back-cover
6. Remove the M.2 2230 solid-state
About this task
The figure indicates the location of the SSD heat-sink and provides a visual representation of the removal procedure.
camera.
assembly.
after working inside your
before working inside your
assembly.
drive.
tablet.
tablet.
Removing and installing components 67