Table of Contents
Advertisement
This chapter gives information about troubleshooting your 54 Mbps Wireless Travel Router
WGR101. After each problem description, instructions are provided to help you diagnose and
solve the problem.
Basic Functioning
After you turn on the power to the router, the following sequence of events should occur:
When power is first applied, verify that the Power light
1.
After approximately 10 seconds, verify that:
2.
The power light is solid green.
a.
The LAN port light is lit only when an Ethernet connection is active. Depending on which
b.
switch position is selected this will refer to a computer or to the Internet connection.
If a port's light is lit, a link has been established to the connected device. If a LAN port is
connected to a 100 Mbps device, verify that the port's light is green. If the port is 10 Mbps, the
light will be amber.
If any of these conditions does not occur, refer to the appropriate following section.
Power Light Not On
If the Power and other lights are off when your router is turned on:
•
Make sure that the power cord is properly connected to your router and that the power supply
adapter is properly connected to a functioning power outlet.
•
Check that you are using the 5 V DC 2A power adapter supplied by NETGEAR for this
product.
If the error persists, you have a hardware problem and should contact technical support.
Troubleshooting
February 2005 (202-10034-03)
Chapter 7
Troubleshooting
is on.
7-1
Advertisement
Table of Contents
Troubleshooting
