Basic Setup Troubleshooting Tips - NETGEAR WGR101 Reference Manual

Select the Encryption Strength (128 bit or 64 bit) for Security Encryption (WEP).
c.
Enter a Passphrase for the Security Encryption (WEP) key. After configuration the
d.
Passphrase can be used to configure NETGEAR equipment instead of entering the WEP
number.
Click Generate to create the WEP key. If using a Passphrase, write it down. Otherwise,
e.
write down the WEP number. This number is needed to configure your computer to work
with the WGR101.
Click Apply to use the WEP keys.
f.
3. C
ONFIGURE YOUR WIRELESS COMPUTER
Set NETGEAR-TRAVEL as the SSID for each computer that will use the WGR101.
a.
Tip: If you are typing the SSID, note that it is case sensitive and must match the WGR101
WGR101 SSID exactly.
The Wireless LED on the WGR101 is on when a wireless connection is available. This
b.
LED flashes during data transfer.

Basic Setup Troubleshooting Tips

Here are some tips for correcting simple problems that prevent you from connecting to the Internet
or connecting to the wireless travel router.
Make sure the network settings of the computer are correct.
• LAN and wirelessly connected computers must be configured to obtain an IP address
automatically via DHCP. For instructions on how to do this, please see the animated tutorials
on the NETGEAR 54 Mbps Wireless Travel Router WGR101 Resource CD (230-10081-02) or
Appendix C, "Preparing Your
• The switch on the WGR101 must be in position 1 for a single user or in position 2 for multiple
users.
• If your hotel asks you to configure your PC with a fixed IP and you want to use the WGR101
with multiple computers, you may need to adjust the Basic Settings. See
Configuration" on page
• Do not connect the WGR101 directly to a DSL modem. This configuration is not supported.
Connecting the Router to the Internet
Reference Manual for the 54 Mbps Wireless Travel Router WGR101
(
S
Network."
6-1.
February 2005 (202-10034-03)
)
"Network
3-9