Installing The Chassis Brackets - Cisco NCS 4201 Hardware Installation Manual

Installing the Chassis Brackets

Installing the Chassis Brackets
Figure 8: Z Rack Mounting Bracket
To install the brackets on the front of the chassis, perform these steps:
Step 1 Remove the rack-mount brackets from the accessory kit and position them beside the chassis.
Step 2
Position one of the brackets against the chassis side, and align the screw holes.The figure below shows how to attach the
brackets on the Cisco NCS 4201 for a 23-inch rack.
Figure 9: Attaching Mounting Brackets to Cisco NCS 4201 for a 23-inch Rack (Front Z-bracket))
Step 3 Secure the bracket to the chassis with the screws removed when performing Step 1. The recommended maximum torque
is 10 in.-lb.
Step 4 Repeat Step 3 and Step 3 for the other bracket.
Cisco NCS 4201 Hardware Installation Guide
34
Installing the Cisco NCS 4201