Table of Contents
Advertisement
Initial Configuration
Default settings are in square brackets '[]'.
Basic management setup configures only enough connectivity for management of the system, extended
setup will ask you to configure each interface on the system.
Basic management setup configures enough connectivity for managing the system; extended setup will ask you to configure
each interface on the system.
Checking the Running Configuration Settings
To check the value of the settings you have entered, enter the show running-config command at the Router#
prompt:
Router# show running-config
To review the changes you have made to the configuration use the show startup-config command in the
user EXEC mode to see the changes and copy run-start stored in the NVRAM.
Saving the Running Configuration to NVRAM
To store the configuration or changes to your startup configuration in NVRAM, enter the copy running-config
startup-config command at the prompt:
Router# copy running-config startup-config
Using this command saves the configuration settings that you created in the chassis using the configuration
mode and the setup facility. If you fail to do this, your configuration will be lost, and will not be available
when you reload the chassis next.
Safely Powering Off the Chassis
This section explains how to shut down the Cisco NCS 4201. We recommend that before turning off all power
to the chassis, you issue the reload command. This ensures that the operating system cleans up all the file
systems. After the reload operation is complete, the Cisco NCS 4201 can be powered off safely.
To power off the Cisco NCS 4201 safely:
Step 1
Slip on the ESD-preventive wrist strap included in the accessory kit.
Step 2
Enter the reload command.
Step 3
Confirm the reload command.
Example:
Rmcp-6ru-1#reload
Proceed with reload? [confirm]
Aug 17 00:06:47.051 R0/0: %PMAN-5-EXITACTION: Process manager is exiting: prs exit with reload chassis
code
Step 4
After confirming the reload command, wait until the system bootstrap message is displayed before powering off the
system:
Checking the Running Configuration Settings
Cisco NCS 4201 Hardware Installation Guide
75
Advertisement
Table of Contents
