Denon DRA-800H Service Manual page 114

Paths to be confirmed Display
fig.A05a
Analog AD
5
A06:AD
(MAIN ZONE) fig.A05b
6 Analog ZONE2 fig.A06
A07:ANALOG-Z2
7 Speaker B fig.A07
A12:SPEAKER-B
fig.A08a
8 ZONE2 Downmix
A22:Z2 Downmix
fig.A08b
Settings
Input Source : CBL/SAT
Input Mode : Analog (fixed)
Sound mode : STEREO
Vol 60(-20dB)
MAIN ZONE : On
ZONE2 : Off
Input Source : CBL/SAT
Input Mode : Auto
Sound mode : STEREO
Z2 Source : CBL/SAT(select a setting other than Source)
Vol 60(-20dB)
MAIN ZONE : On
ZONE2 : On
Input Source : CBL/SAT
Input Mode : Analog (fixed)
Sound mode : DIRECT
Speaker Select : B
MAIN ZONE : On
ZONE2 : Off
Input Source : CBL/SAT
Input Mode : Auto
ZONE2 Source : Source
ZONE2 Vol : 60
MAIN ZONE : On
ZONE2 : On
114
What to confirm
• Analog input ⇒ Speaker output (Front L/R, Center, Surround L/R)
• Analog input ⇒ SW(20Hz)
( b The input source can be switched to any source except CBL/SAT.)
( b Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)
• Analog input ⇒ Pre OUT output (ZONE2 L/R)
( b Source for ZONE2 does not change even when Source for the main zone is changed.)
( b The input source for ZONE2 can be switched to any source except CBL or SAT.)
( b Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)
• Analog input ⇒ Speaker output (Left/Right B)
( b The input source can be switched to any source except CBL/SAT.)
• Analog input ⇒ Pre OUT output (ZONE2 L/R)
( b The input source can be switched to any source except CBL/SAT.)
(Leave the ZONE2 Source as Source.)
( b Volume 60 is the value when Absolute settings are used. The value is -20 when Relative set-
tings are used)