Denon DRA-800H Service Manual page 110

Network stereo receiver
Hide thumbs Also See for DRA-800H:
Table of Contents

Advertisement

3-4. TUNER STEP mode (E3 only)
3-4.1. Actions
This is a special mode that enables the reception frequency STEP of the FM/AM TUNER to be changed.
3-4.2. Starting up
While holding down buttons "ZONE2 SOURCE", "SPEAKER" and "STATUS" simultaneously, press the
power button to turn on the power.
Select the "5. TUNER FRQ SET" using the "TUNER PRESET +/-" button, then press the "STATUS"
button then to confirm.
3-4.3. Displays
Start up this unit in TUNER STEP mode, select the desired option using the "TUNER PRESET +/-"
button, then enter using the "STATUS" button.
The following information is displayed in the following order.
(1) AM9 kHz / FM50 kHz is selected
<
AM9/FM50
>
"TUNER PRESET +"
"TUNER PRESET -"
(2) AM10 kHz / FM200 kHz is selected
< AM10/FM200 >
"STATUS"
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
3-5. Remote ID Setup Mode
3-5.1. Actions
This function allows only the desired AV receiver to be operated if multiple DENON AV receivers are
used in the same room.
3-5.2. Starting up
While holding down buttons "ZONE2 SOURCE", "SPEAKER" and "STATUS" simultaneously, press the
power button to turn on the power.
Select the "6. REMOTE ID" using the "TUNER PRESET +/-" button, then press the "STATUS" button
then to confirm.
3-5.3. Operations
(1) When Remote ID Setup mode is activated, the following message is displayed.
REMOTE ID ?
(2) Press the desired "QUICK SELECT 1 - 4" button.
Button
QUICK SELECT 1
REMOTE ID 1
QUICK SELECT 2
REMOTE ID 2
QUICK SELECT 3
REMOTE ID 3
QUICK SELECT 4
REMOTE ID 4
(3) Press the power button to turn off the power.
(4) Press the power button to turn on the power.
b Only "QUICK SELECT 1 - 4" and the POWER button on the unit can be used in Remote ID Setup
Mode.
b The remote ID of the remote control supplied with this unit cannot be changed.
NOTE :
If the ID of the unit and remote control do not match, "AVAMP z " appears on the display of the unit
when the remote control is used
( z : own remote control ID).
110
Display

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents