Entering A Loadlist From A Host Or Laboratory/Hospital System - Siemens CLINITEK Advantus Operator's Manual

3. If needed, enter or scan the color and clarity.
4. Select or scan the
Enter
5. Repeat steps 2 to 4 for each specimen.
Editing a Loadlist
Use this procedure to make changes to the loadlist when initial entry is
complete.
1. Use and
Move Up
2. Edit the ID number.
You cannot change or delete the ID number during Run mode.
NOTE:
Make any changes while the analyzer is in the Ready mode.
3. Select to delete an item from the loadlist.
Delete
You can delete only the ID number being displayed or all IDs in memory.
4. Edit the color and clarity.
5. Select to accept the new number, color, and clarity.
Enter

Entering a Loadlist from a Host or Laboratory/Hospital System

You can connect the Clinitek Advantus analyzer to a host computer or
laboratory system. Refer to Appendix G, Computer and Printer Interface, for
more information.
1. Before sending a loadlist from a host or laboratory system, ensure that the
following conditions are true:
• The analyzer is at the Ready/Run screen.
• No IDs from an earlier loadlist are still stored in the analyzer. If a loadlist
was sent but is no longer needed, you can overwrite the unused IDs
with a new loadlist.
• The computer port is set to computer port, ethernet port, or both.
• The computer port options for Baud, Data, and Parity are correct for the
computer or LIS/HIS sending the loadlist. Refer to the specifications
accompanying the computer or Laboratory/Hospital Information System
for information on the required parameters.
• The output format for the computer port is CCS. Refer to Computer Port
Options‚ page 104 for more information on setting the computer port.
NOTE
: Loadlist data is only transferred if it is formatted correctly. If a
loadlist is not transferred, refer to Section 6, Troubleshooting, for possible
causes.
22
code.
Enter
to select the record to edit.
Move Down
Clinitek Advantus Operator's Guide