Toshiba RAV-SM561KRT-E Installation Manual page 23

10
INDOOR UNIT OPERATION WHEN CONNECTED TO MULTIPLE UNITS
Procedure
Specify the CODE No. [13] with the temperature [
4-1
(CODE No. [13] : Indoor address).
Change the indoor address from [3] to [2] with the timer time
4-2
[ /
Push SET
4-3
If the display changes from flashing to being lit, the setting is completed.
Specify the CODE No. [14] with the temperature [
5-1
(CODE No. [14] : Group address)
Change the set data from [0001] to [0002] with the timer time
5-2 [ /
(Set data : [Main unit: 0001] [Sub unit: 0002])
Push SET
5-3
If the display changes from flashing to being lit, the setting is completed.
If there are some other indoor units of which setting is to be changed, repeat
the procedure 2
After the above setting is completed, push
No. which had been given prior to the setting change, and then specify the CODE
No. [12], [13] and [14] with the temperature [
successively to confirm the changes made.
Check of address change Prior to the change [3-3-1] → After the change [2-2-2]
6
The setting change which has been made can be cleared by pushing
(In this case, perform the setting again from Procedure 2.)
After checking the changes made, push
confirmed). If
conditioner will be in ordinary stop state.
(The commands from the remote controller cannot be received for approximately 1
7
minute after pushing
• If the commands from the remote controller is not received even after 1 minute
has elapsed, the address setting may be incorrect. In this case, perform the
setting again from Procedure 1 as the automatic address setting has been
made again.
3
Toshiba 1074007701(01EN)_P11-22
] button.
button.
] button.
button.
2 – 5 2 2 2 5 to change the setting. 5 5 5
button is pushed, the display will disappear and air
button.)
21
Description
/ ] button.
/ ] button.
UNIT button to select indoor unit
/ ] button
CL button.
button (the changes will be
20
7/16/04, 13:31
TOSHIBA RAV-SM561KRT-E (EN) 1074007701
Indoor unit numbers which had been
given prior to the setting change will
be displayed.
CODE No.
SET DATA
UNIT No.
R.C. No.
CODE No.
SET DATA
UNIT No.
R.C. No.
Indoor unit numbers which had been
given prior to the setting change will
be displayed.
CODE No.
SET DATA
UNIT No.
R.C. No.
CODE No.
SET DATA
UNIT No.
R.C. No.
Indoor unit numbers which had been
given prior to the setting change will
be displayed.
CODE No.
SET DATA
UNIT No.
R.C. No.
CODE No.
SET DATA
UNIT No.
R.C. No.
CODE No.
SET DATA
UNIT No.
R.C. No.
EN